ObShape -How to dimension a Counter bore

website slot dimension callout A slot in a plastic molded part may have draft This complicates how it should be dimensioned Below is a best practice for how to dimension slots with draft slot slot ○ Dimension values in drawing refer to the full size of the object 6 Dimensioning slots Page 30 Ahmed Kovacevic, City University London Design

slot dimension callout objTempStyle = objDimStyles 'Set the simple slot callout property SlotCalloutCounterbore property for dimension style ) End If Catch ex As  Is there any way to have a hole callout dimension on an inch drawing for a just a couple holes that you want called out in Metric?  Dimensioning, Continued Slotted holes Dimension slotted holes by width, length, or center points Indicate the end radii but do not dimension them Figure 3

Share

Share

Link

Turn off sharing Copy link

See all details